MyBB Community Forums

Full Version: ProPortal v. 1.0 - You didn't create any block.
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Greetings.

I just installed ProPortal v1.0 from here:
http://community.mybb.com/thread-63463-p...#pid647748

Well, after following the installation guide I got to my portal.php and it just says "You didn't create any block." everywhere.

Then I trought I had to make enable some blocks in the Admin Panel.

But then I saw they was all enabled.

Does anyone have any ideas what is wrong.

Link to mine:
http://www.gamerstick.com/portal.php
Edit and active each block on Admin Panel -> Proportal
(2012-05-27, 03:13 PM)niere8 Wrote: [ -> ]Edit and active each block on Admin Panel -> Proportal

Thanks a lot.

I found out that I had to select each usergroups before it gets shown.
(2012-05-27, 03:22 PM)Dead Soul™ Wrote: [ -> ]
(2012-05-27, 03:13 PM)niere8 Wrote: [ -> ]Edit and active each block on Admin Panel -> Proportal

Thanks a lot.

I found out that I had to select each usergroups before it gets shown.

when i first used proportal i did the exact same Big Grin